QIACHIP 433Mhz Universal Wireless Remote Control Switch AC 110V 220V 1CH Relay Receiver Module & Unlimited battery transmitter

QIACHIP 433Mhz Universal Wireless Remote Control Switch AC 110V 220V 1CH Relay Receiver Module & Unlimited battery transmitter
  • Продавецprada-handbags-sale.us
  • Список ценUS $29.80piece
  • Продажная ценаUS $29.80piece
  • ДоставкаБесплатная доставка
  • Рейтинги3,6 (183)

Oписание продукта

ACHIP Self Powered Wireless Transmitter Remotes Light Fan Wall Switch RF Receiver Self-Power Battery-Less Remote Control Kit

Energyharvesting technology

Self powered smart switch

 The receiver can receive the RF signal from self-powered wireless switch, and control the output of the load.

This receiver can provide “on” and “off” output of 1-channeled relay.

Can pair with several switch panels in order to realize the smart multi-control.

20171124_163446_001

20171124_163446_000

The self-powered wireless switch is a wireless transmitter without battery, which is used with wireless receiver usually. It can remote-control the receiver, therefore it can remote-control the load (lights, fan, etc.) connected with the receiver.

 

【Package Include】

1x Wireless Receiver

1 x Remote controller (self-powered, No need battery inside,environmental protection)

2 x Instructions

1 x  gummed paper

20171124_163446_003

【Switch Technical Data 】

Power supply:  Self-powered,without extra power supply

Key Type:  on/off or toggle, depends on switch type

Life Time:  >100 000 cycles

Condition:  -20°~60°

 

【Installation and Operation】

Attention:

It cannot be fixed in metal box, near or on the ground and near a big block of metal. Otherwise, it’s difficult for the receiver to receive the radio signal. 

20171124_163446_004

Pairing A New Switch To The Receiver

1. Enter into the pairing mode

2.  2 Ways of pairing

  • Way 1: Keep pressing the control button (as the above photo)  for 3 seconds, until the output light flashes.
  • Way 2: Within 5 seconds of power on of the receiver, press the switch 3 times quickly, and then the output light begins to flash.

3.Press the wireless switch.

 

Note: During pairing, if press control button or no operation is done within 30 second, the receiver will quite pairing mode.

 

Clear the Paired Switch

 ·Way 1: Clear through button 

  Keep pressing the control button for at least 10 seconds until 2 cycle of quick flash appears. At this time all paired switch will be cleared.

· Way 2: Remote Clean

  Within 5 seconds after receiver power on, press the switch 5 times quickly. 2cycle of quick flash will appear on receiver. At this time, the receiver will clean all paired switch.